Infiniton SD-7AV - Cleaning and Maintenance; External Cleaning; Cleaning the Door

35 inniton.es
WARNING! Before cleaning, unplug the power plug rst; do not connect or disconnect the power
plug with wet hands, as there is a risk of electric shock and injury.
Do not spill water directly on the appliance, thus avoiding rust, electricity leakage and accidents.
Regular cleaning of this appliance helps to prolong its life.
External cleaning
Clean dust accumulated on the surface of the appliance frequently.
After using detergent, be sure to rinse it with clean water and then wipe it dry with a cloth.
Note: Never use metal scouring pads as this may damage painted, chrome and plastic surfaces.
WARNING! Do not use bristle brushes, wire brushes, detergent, soap powder, alkaline detergent,
benzene, gasoline, acid, hot water and other corrosive or soluble elements to clean the surface of the
appliance, door gasket, plastic decorative parts, etc. to avoid damage. Carefully dry the door gasket,
clean the groove with a wooden stick wrapped with cotton thread.
Cleaning the door
Clean the glass and door gasket after each wash to remove
possible lint and/or detergent/softener residues, as leaks may
occur.
If any rust stains are found inside the drum, they should be
removed with non-chlorine detergent.
Cleaning & Maintenance
English
Cleaning the lters
This tumble dryer has a main lint lter in the door.
Be sure to clean the door lter after each cycle.
Note:
In order for the double-layer lter to close smoothly, it is necessary to align the
arrows at both ends, as well as the centre slot and the side slot.
slot.
Cleaning the door lter
1. Open the door.
2. Remove the door lter.
3. Open the lter and remove the lint from the lter, you can clean it under running
water.
4. Dry the door lter thoroughly before reinstalling it.
Observe the correct orientation before inserting the door lter.