Infiniton SD-7AV - Troubleshooting

37 inniton.es
Troubleshooting
Whenever there is a problem with the appliance, check if you can solve it by following the tables below.
If the problem persists, contact customer service.
Cleaning & Maintenance
English
Note
If you cannot solve the problems yourself and need help:
- Press the button (On / Off).
- Disconnect the mains plug from the mains and call for service.
DESCRIPTION CAUSE SOLUTION
Does not start Power failure.
The plug is not properly con-
nected.
The temperature of the laundry
is too high.
The temperature fuse is discon-
nected.
Wait until the power is on.
Check the socket, make sure that the plug is
properly connected.
The laundry in the dryer must be after spin-
ning, and the laundry to be dried must not
exceed 3 kg.
Call the service technician to reset the tem-
perature fuse.
Hot or smells burnt The lint lter is dirty.
The suction or exhaust duct is
dirty.
Make sure to clean the lint lter well in ad-
vance.
Clean the tube.
Clothes too dry There is too much laundry in the
dryer.
Laundry is not taken out in time
when nished.
Laundry is not sorted correctly.
Temperature is too high.
Make sure there is no overload of laundry.
Take the laundry out immediately when
nished.
Respect the maintenance label on the laun-
dry.
Clothes shrink Too dry Observe the care label on the laundry. If clo-
thes shrink easily, examine them when they
are dry. Remove clothes when they are too
wet or too dry and hang them up until they
are completely dry.
Lint forms on clothes It is correct that synthetic bres
and permanent press bre
cause hairballs. This is because
the correct rubbing causes the
formation of uff.
Use fabric softener to lubricate the bre,
when ironing clothes, apply a little fabric sof-
tener to the cuffs and neckline, turn the iron
outwards to reduce rubbing.