Need help?Do you have a question about the Infinity Alpha Series and is the answer not in the manual?
Keep packing material for future use, such as moving or service.
Experiment with locations to achieve the best overall balance and imaging.
Place speakers 2-3 meters apart and angle them towards the listening position.
Avoid placing speakers directly against walls or in corners to prevent boominess.
Thread nuts, screw feet into sockets, and adjust for equal height.
Use two-conductor insulated wire, minimum 1.3mm (16 AWG) diameter.
Connect red to red (+) and black to black (-) for correct phase.
Consult dealer/manufacturer for connecting multiple speaker pairs safely.
Remove metal bars between high and low inputs before bi-wiring.
Improves resolution and dynamics; can be combined with bi-amping.
Overdriving amplifiers creates distortion that can damage tweeters.
Use an amplifier that plays loud cleanly; avoid excessive tone control boost.
Magnetically shielded, place above or below TV, flush with front edge.
Connect in phase (plus-to-plus, minus-to-minus) like front speakers.
Dust with damp cloth or furniture polish; clean grilles with low power vacuum.
Listen to each speaker separately to isolate faults within the system.
Check driver terminal wire connections; reconnect if loose.
Substitute drivers between speakers to identify a defective unit.
Return the system to the dealer or contact your local Infinity Distributor.
To Next Page
General