11
Put the seatrest cushion firmly on the seat
board. Then, zip up the zipper of the front seat
cushion.
Place the large headrest pillow to the backrest
flap and attach it to the Velcro on the back of
the chair.
Place the small headrest pillow on top of the
large headrest pillow, and attach it to the Velcro
on the back of the chair. Install the remote
holder, loosen the pre-screwed screws from
the right armrest, and then install the holder
with the existing two screws using Philips
Screwdriver. Plug the wire connector of remote
control into the power switch box, and put the
remote controller into the holder.
Check again to make sure all steps are done
properly. The chair is ready for use.
Plug in power cord to chair and wall outlet.
The foot extension length can be adjusted to 7 cm, 8 cm or 10 cm. Lift up the footrest,
and use Long Nose Pliers to take out the E type clip. Remove the bolt to set the hole in
preferred length. Then, put back in the bolt and lock in the E type clip.
Step 4
Step 5
Step 6
Adjusting The Legrest Position
Step 7
To Next Page
Loading...
