Infinity LEGEND - Debounce Programming; Eye Mode Programming; Firing Mode Programming

Debounce
Pull and release the trigger once for every 1ms of time you want the setting to be. For example, if you were programming
the debounce to 6ms, you would pull and release the trigger 6 times. The default Debounce setting is 10ms.
Eye Mode
Pull and release the trigger the number of times necessary to set the Eye Mode to what you want to use.
The following is a list of possible Eye Modes and the ashes (also trigger pull required):
1 ash - Eye Mode 1 (Bypassed mode)
2 ashes - Eye Mode 2 (uses MROF cap)
3 ashes - Eye Mode 3 (monitors bolt) also known as force Mode
4 ashes - Eye Mode 4 (Simulate mode)
If you pull and release the trigger more than 4 times, then the LED will toggle green/red alternately to indicate there was a
programming error, and then go back to the programming menu. The default Eye Mode is 3
BIP Delay
The BIP Delay is a programmable time delay between when the eye sensor rst sees the ball until the bolt starts its
forward travel.
Pull and release the trigger once for every 1ms of time you want the setting to be. For example, if you were programming
the BIP Delay to 5ms, you would pull and release the trigger 5 times. The default BIP Delay setting is 3ms.
MROF Cap
Pull and release the trigger once for the number of times you want the Max. Rate of Fire (MROF) cap to be. For example,
20 pulls/releases would be 20 bps MROF. The MROF cap is only used with Eye Mode 2. In Eye Mode 3, the max. rate of
re is unlimited. The default MROF cap is 20 bps.
Eye Power
Pull and release the trigger once for the number of times you want the Eye Power to be. Each trigger pull/release
represents a level increase. So, a setting 5 would make the eye more powerful (able to see through liquid paint) than a
setting of 4. Higher values use more battery power. The default Eye Power is 20.
Firing Mode
Pull and release the trigger the number of times necessary to set the Firing Mode to what you want to use.
The following is a list of the possible Firing Modes and the ashes (trigger pulls required):
1 ash = Semi-Auto (NPPL Legal)
2 ashes = 3 shot ramping (PSP Legal)
3 ashes = 3 shot full auto (NXL Legal)
If you pull and release the trigger more than 3 times, then the LED will ash green/red alternately to indicate there was a
programming error, and then go back to the programming menu. The default Firing Mode is 1.