Infinity Reference RS-8 User Manual

RS-8 – Owner’s Manual
◆
5
THE REFERENCE SERIES (RS)
All RS Series products use efficient drivers for maximum output with minimal amplifier
power. They are magnetically shielded, making them suitable for home-theater
applications as well.
UNPACKING THE SPEAKERS
If you suspect damage from transit, report it immediately to your dealer and/or delivery
service. Keep the shipping carton and packing materials for future use.
These speakers are covered by a Limited Warranty, so save the sales receipt to protect your
purchase and aid in any service-related questions. Also, save these instructions for future
reference.
INSTALLING FEET
Refer to Figure 1 as you perform the following steps:
1. Open each accessory pack and locate the following items: four feet (with spike/round
ends), four locking nuts, four nylon domes and one wrench.
2. Lay each speaker on its side and locate the four threaded holes on the bottom.
3. For carpets, screw the round end of a foot into each hole and hand tighten a nut onto each
one. Leave a minimum of
5
⁄8" exposed spike. (On thicker carpets, you can increase the
length of exposed spike up to 1
1
⁄8".) For hard-surface floors, screw the spike end into each
hole instead and leave
5
⁄8" of round end exposed.
4. Carefully flip each speaker upright to sit on its feet.
5. If needed, adjust the feet so each speaker is level and then tighten each nut with the
enclosed wrench. To protect hard surfaces (e.g., wood floors), slip a nylon dome onto each
round end.
Figure 1. This cross section shows
how to install a foot onto the bottom of an
RS-8 floorstanding speaker.
Nylon Dome
(optional for
wood floors)
Locking Nut
HARD-SURFACE
FLOORS
CARPETED
FLOORS
Foot
round end
spike end
Bottom
Of Speaker
5
⁄8"
5
⁄8" min.
1
1
⁄8" max.

Infinity Reference RS-8 Specifications

General

Brand	Infinity
Model	Reference RS-8
Category	Speaker System
Language	English