How to fix over temperature on InFocus IN5312 Projector?
If the InFocus Projector indicates an over temperature condition, ensure that the projector's ventilation is not obstructed, allowing air to circulate freely. This helps prevent overheating.
How to fix 'Lamp strike fail' on InFocus Projector?
If the InFocus Projector reports 'Lamp strike fail', the lamp needs to be replaced.
How to fix 'Color wheel fail' on InFocus IN5312?
If the InFocus Projector indicates 'Color wheel fail', adjust or replace the color wheel.
What to do if InFocus Projector shows 'Case open'?
If the InFocus Projector shows 'Case open', make sure the projector case is securely closed.
What to do if InFocus Projector shows Fan 1 error?
If your InFocus Projector displays a 'Fan 1 error', 'Fan 2 error', or 'Fan 3 error', check whether the fan is obstructed or not working correctly. Clear any blockages or address any malfunction to resolve the error.
Why does my InFocus IN5312 Projector show 'Ballast said OVT when Lamp strike'?
In case of 'Ballast said OVT when Lamp strike' error, check the InFocus Projector for potential overheating problems.
What to do if InFocus Projector displays 'Ballast said OVT when SYS operation'?
In case of 'Ballast said OVT when SYS operation' error, turn off or disconnect devices that could be causing excess heat in your InFocus Projector.
What to do if my InFocus IN5312 Projector says 'Ballast said Lamp off'?
If the InFocus Projector displays 'Ballast said Lamp off', verify the lamp connection to ensure it is properly connected.
General| Brightness | 5000 ANSI Lumens |
|---|---|
| Resolution | XGA (1024 x 768) |
| Contrast Ratio | 2000:1 |
| Max Resolution | 1920 x 1200 |
| Display Technology | DLP |
| Projection Size | 30 - 300 inches |
| Connectivity | HDMI, VGA, USB |
| Throw Ratio | 2.15:1 |
To Next Page
