InFocus LightPro IN1044 - Power off Your Projector

www.infocus.com
Basic operation
34
Power o your projector
1. PressthePowerbuttonatthetopcontrol
panelortheremotecontrol,the“Powero?”
messagedisplays.
2. PressthePowerbuttonagainin4seconds
afterthe“Powero?”messageprompted
toyou.ThePOWERindicatorashesred
whilethecoolingfancontinuesrunning.(You
maysetupnoiselevelandspeedofthefan.)
Unplugthepowercorduntilthefanstops
running.Failuretodosomayshortenlife
cycleofyourprojectororleadtopoweron
failuresoroperationabnormalities.
3. ThePOWERindicatorstopsashingonce
theprojectorhasbeencooleddowntoready
forpoweronagain.
Tomaintainthelifecycleofthelamp,onlypoweroyourprojectorafterithas
beenturnonforatleastveminutes.
Donotleaveyourprojectorturnedonforextendedperiodsoftime.Asitmay
hurtthelifecycleofyourlamp.Poweroyourprojectoratleastonceevery
24hoursandhaveitidleforanhour.
Powero?
“Powero?”message
disappearsin4seconds.
Note
• Ifthe“Directpoweron”functionissetto“On”,yourprojectorwillpowerononce
itisconnectedtoanACpowersocket.
• Speedofthecoolingfanspeedvariesbasedontheinternaltemperatureofyour
projector.
• Donotplaceyourprojectorinanyboxbeforeitisfullycooleddown.
• IncasethePOWERindicatorashesorturnsred,refertothe“WARNINGlight
indicator”forinstructions.
• ThePOWERindicatorasheswhenthelampiscoolingdown.Donotpoweron
yourprojectoratthistime.PoweronyourprojectoronlyafterthePOWERindicator
turnsred.
• Unplugthepowercordafteryourprojectorhasbeenturnedo.Thefanstops
running.
• ThePOWERindicatorturnsredwhenyourprojectorisreadyforpoweronagain.
Ittakeslesstimetorestartyourprojectorafteritwaspoweredointhestandard
poweroprocedurethanthatofthenon-standardone.