LitePro 580 User’s Guide 33
Using LP Utilities
The LitePro 580 projector provides even greater ease of use with LP
Utilities, which include two software programs: LP-Link and LP
Remote Programmer.
LP-Link allows you to operate the projector directly from the
computer.
LP Remote Programmer allows you to use the trackball and five
programmable buttons on the remote control to operate the
presentation software and control projector functions. To use these
utilities you must connect your computer to the projector with the LP
serial cable and run the LP Utility software.
Connecting your computer
To connect the projector and your computer, use the LitePro Utilities
serial cable (and adapter if needed) provided with the projector.
1.
Turn off your computer, monitor, and LitePro projector.
2.
Plug the round, 8-pin connector of the LP serial cable into the LP
Serial port on the projector.
3.
Plug the other end of the LP serial cable into the serial port on the
computer. For a Macintosh, attach the Mac adapter to the serial
cable and plug it in the modem or printer port.
If your IBM-compatible has only a 25-pin serial port,
you will need a 25-pin serial adapter. This adapter is
available at most computer supply stores.
Downloaded From projector-manual.com Boxlight Manuals
To Next Page
Loading...
Need help?
General