InFocus LiteShow - Step 1: Check Your Equipment

InFocus LiteShow Quick Start Guide 1
‘This InFocus
®
LiteShow
®
Quick Start Guide contains the four simple steps you need to perform in order to project with-
out the burden of cables. If you have any problems, consult the "Troubleshooting" section of the LiteShow User’s Guide
or the program’s online Help. Technical Support contacts can be found in this document on page 14.
Step 1: Check Your Equipment
Before you get started, check the System Requirements for your projector, PC or Mac to make sure that you have all of
the proper equipment. Then, check the "Items for Installation" section on page 3 to be sure you have all of the Lite-
Show components that you need.
System Requirements
Projector
Projectors that work with LiteShow for wireless projection need an M1-D or M1-DA standard connector (see below).
The LiteShow adapter attaches to your projector via this connector. For a list of projectors that are compatible with
LiteShow, consult the "Compatible projectors" section in the "Appendix" of the LiteShow User’s Guide.
connector on your projector