4 InFocus LiteShow Quick Start Guide
Step 2: Attach the LiteShow adapter to your Projector
1 Make sure that the projector you are going to attach LiteShow to is powered off.
2 Attach the LiteShow adapter to the M1-D or M1-DA connector on the projector. Secure it to the projector with the
two thumbscrews. Be careful to not overtighten them.
3 Power on the projector. Look for the LiteShow Splash Screen (shown on the next page) on the projected screen. The
LiteShow Splash Screen is a small window that appears in the upper left corner of the projected screen. If you can
see it, then you know that the projector is powered on, the M1-D or M1-DA connector is the active source, and that
a LiteShow adapter is connected to it.
thumbscrews
Connector
hinge
To Next Page
Loading...
