LP600 Keycodes
The LP600 uses the NEC IR protocol.
The customer code portion of the IR packet should use the hexadecimal value 0x4E87.
Key Name Code Description
Menu 0x02 Toggles menu state up or down
Brightness Plus 0x03 Increases brightness
Brightness Minus 0x07 Decreases brightness
Standby 0x0D Toggles standby state on or off
Freeze 0x0E Toggles freeze state on or off
Source Select 0x10 Selects next available source
Cursor Up 0x13 Moves menu cursor up
Cursor Down 0x14 Moves menu cursor down
Power 0x17 Toggles power state on or off
Keystone Plus 0x20 Increases keystone
Keystone Minus 0x21 Decreases keystone
Presets 0x2C Toggles through available presets
Source1 0x2D Selects programmed source
Source2 0x2E Selects programmed source
Source3 0x2F Selects programmed source
Source4 0x30 Selects programmed source
Blank 0x31 Toggles state of blank screen on or off
Select 0x32 Selects current menu item
Auto Image 0x33 Activates automatic image re-acquisition
Resize 0x34 Toggles through available resize modes
Overscan 0x35 Toggles overscan state on or off
Contrast Plus 0x36 Increases contrast
Contrast Minus 0x37 Decreases contrast
Discrete Power OFF 0x39 Turns power off (Home Entertainment special)
Discrete Power ON 0x3A Turns power on (These do not exist on any remote)
Native Resize 0x3B Selects Native Resize
16:9 Resize 0x3C Selects 16:9 Resize
4:3 Resize 0x3D Selects 4:3 Resize
Letterbox Resize 0x3E Selects Letterbox Resize
Need help?
General
