InFocus LP70 - Setting up the Projector

11
Powering up the Projector
NOTE: Always use the power cord
that shipped with the projector.
1 &!
2 ?#"A
'#
!!
G
3*BI88J
3 ?
Power
"A
NOTE: The first time you connect
your computer to the projector, the
computer may display a message
stating that new hardware was
found. The Add New Hardware
Wizard may appear. Use the Wiz-
ard to load the correct driver (the
computer considers the projector a
Plug and Play Monitor).
G
"3*B"A
I88J"A'

(!"!"'

4 "
G
!A"
H
Source/Select
(

Video
!I $9J
!
5 "!
"!!A'
!FAN##O
/#@#F#
FI#
###!J
LP70.book Page 11 Tuesday, July 30, 2002 7:24 AM