INFOCUS
32
failure, network failure caused by PC virus until the PC can be Ping.
2. Disconnect IP Camera with network, IP Camera and PC are connected, according to the
proper operations to re-set the IP address.
3. Check the server's IP address and subnet mask and gateway address.
4. MAC addresses conflict.
5. Web port is occupied by other devices.
When modify IP address in an incorrect way cause the wrong IP address or forget web passwords,
press the IR remote controller "[*]+[＃]+[Manual]" to restore the default value (Default IP:
192.168.100.88 Default username: admin Default password: admin)
Control
IR remote controller cannot control the camera
1. Change the battery
2. Check the camera working mode.
3. Check IR address of the Remote Commander is set correctly.
Serial communication cannot control the camera
1. Check the camera working mode.
2. Check control cable is connected correctly.
To Previous Page
Loading...