7
6.3 Water connection (fixed mount)
Under the lower plane is visible the pipeline loading and unloading. Splice the tube of load with
the pipeline using a flexible pipe. Splice the unloading of the tank to siphon of the pipeline of drain
installed in the premises (See annex Nº1).
6.4 Electrical connection.
The electrical connections must be carried out by qualified personnel in compliance with local
regulations. The electrical circuit of the device is designed to work well with the machine as a supply
voltage of 380 Volts tri-phase with neutral frequency 50/60Hz, or with a single-phase supply voltage 230
Volts single-phase frequency 50/60Hz.
See wiring diagram based on the model purchased.
The cable must meet the minimum requirements of type H05 RNF and having a conductive
ground efficiently and correctly sized based on the total power of the device.
The electrical power supply of the device must be equipped with a properly sized circuit breaker
pole to ensure a quick disconnect and have some contacts of at least 3 mm.
The ground wire must not be interrupted. The electrical safety of this machine is guaranteed
only when the above conditions are met.
The manufacturer declines all responsibility in the event of non-compliance as described in
this manual.
7. OPERATION AND USE
7.1 Advice for use
• This series of appliances must be used only for the purpose for which they were designed: that
is, keep the food in GN trays in the hot elements, in the cold elements and in the ceramic hob.
The lower interior part of the hot elements serves for the storage or heating of crockery. Do not
To Next Page
