Start-up
1. Battery Installation
a. According to fgures, remove battery compartment lid with
specified battery key
b. Insert batteries with correct polarity according to battery lid
indications
c.Close the battery compartment lid and skew tight with the
battery compartment key
*Caution:
1. Please do not mix new and old hatteries. Use alkaline batteries
or rechargeable batteries only
2. Please replace batteries when the symbol flashes permanently
in the display
3. Please remove the batteries before any long period of non-use
4. Flat batteries must not be disposed of with household waste
Care for the environment and take them to the collection points
provided in accordance with national or local regulations
Equipment Operation
Switch on and off
Lang-time press
button to switch on the
equipment with default reference setting of
single measurement made, rear reference
and metric unit system; At the same time
battery state and laser reflection signal
intensity indication as shown as figure C;
To Next Page
Loading...