Measurement
Single-mode Measurement
When equipment is switched on,pressing
the laser and aim the laser onto target and pressing
again will trigger single-mode measurement, the resuit is will
results displayed immediately as shown in figure E.
Continuous-mode Measurement
When the equipment is switched on, long-lime pressing
flashing
MIN:MINIMUM VALUE
MAX:MAXIMUM VALUE
Current measurement value is displayed in LCD bottom line as
shown in figure F
Functions
Area,VOlume,lndirect Measurement (Pythagorean Theorem)
Press button to change measurement
functions,respectively,as shown in figure
G;select corresponding function and begin the
measurement:
button will activate
button
button
will trigger continuous-mode measurement with symbol
To Next Page
Loading...