INGENIA IG3T - Updating the Firmware

67
INGENIA IG3T Cod. 420120239 REV. 1.1
5. UPDATING THE FIRMWARE
1. Download the USB BURNER MANAGER in the “SOFTWARE & CONTROLLER” section, then install it following
the relevant instructions
2. Download the .zip le of the latest rmware in the “DOWNLOADS” section for INGENIA IG3T
3. In the top right section of the USB BURNER MANAGER screen, select “File Opening”
4. Select the previously downloaded rmware le (verifying that it is appropriate for your operating system)
5. Click UPDATE
It is very important that you keep the product rmware always up-to-date, to ensure its full functionality.
Periodically check the Web site http://www.dbtechnologies.com, in the “DOWNLOADS” section. Once you verify
that a new rmware version is available:
ATTENTION!
When the rmware is updated the presence of the old saved settings
at the next switch-on is not guaranteed.
English