Ingersoll-Rand Sierra H 250 User Manual (English)

Questions and Answers:

A
Amy BaileyAug 25, 2025
What causes a Ingersoll-Rand Air Compressor to fail to load?
- K
  Kelly HollandAug 25, 2025
  If your Ingersoll-Rand Air Compressor fails to load, start by checking for leaking seals in the hydraulic cylinder. If the cylinder doesn't fully stroke when the 'Load' button is pressed, overhaul the hydraulic cylinder. Also, check for a defective load solenoid valve by removing the tube that runs from the load solenoid valve to the hydraulic cylinder. Start the compressor and press the 'Load' button; if oil doesn't come out of the solenoid valve, replace it.
N
Nicole RodgersAug 27, 2025
How to get rid of water in Ingersoll-Rand Sierra H 250 system?
- J
  johnsonjenniferAug 27, 2025
  If you find water in your Ingersoll-Rand Air Compressor system, start by inspecting the moisture separator/drain trap for defects and clean if required; replace if defective. Check the trap drain and drain piping for any blockages and clean them. Inspect and clean the aftercooler core if it's dirty. Ensure all enclosure panels are in place. If the unit lacks an aftercooler, consider installing one. Finally, ensure the drain line/drip leg is correctly installed, sloping the drain line away from the trap and installing a drip leg.
J
James BrockAug 31, 2025
Why is my Ingersoll-Rand Sierra H 250 Air Compressor making so much noise?
- K
  Kirsten GonzalesAug 31, 2025
  If your Ingersoll-Rand Air Compressor has an excessive noise level, inspect and tighten any loose component mountings. Ensure that all enclosure panels are in place. If the compressor itself is defective, contact an authorized distributor immediately and do not operate the unit.
M
Matthew FischerSep 4, 2025
What to do with excessive vibration of Ingersoll-Rand Sierra H 250 Air Compressor?
- A
  Anthony MullenSep 4, 2025
  If your Ingersoll-Rand Air Compressor is experiencing excessive vibration, inspect and tighten any loose components. If the motor or compressor bearing has failed, contact an authorized distributor immediately and do not operate the unit. Inspect the area for other equipment that may be causing external vibrations.
S
Scott HaydenSep 7, 2025
Why does the pressure relief valve keep opening on my Ingersoll-Rand Air Compressor?
- S
  Shane PattersonSep 8, 2025
  If the pressure relief valve on your Ingersoll-Rand Air Compressor opens, it could be due to the compressor operating over pressure; adjust the controller set points. Alternatively, the valve itself may be defective and require replacement.