Ingersoll-Rand TAM9A0A24V21DA User Manual

SSAAFFEETTYY WWAARRNNIINNGG
Only qualified personnel should install and service the equipment. The installation, starting up, and servicing of heating, ventilating, and
air-conditioning equipment can be hazardous and requires specific knowledge and training. Improperly installed, adjusted or altered
equipment by an unqualified person could result in death or serious injury. When working on the equipment, observe all precautions in the
literature and on the tags, stickers, and labels that are attached to the equipment.
June 2017
1188--GGJJ8822DD11--11BB--EENN
Variable Speed Air Handlers
Convertible 2 — 5 Ton
TAM9A0A24V21DA
TAM9A0B30V31DA
TAM9A0C36V31DA
TAM9A0C42V41DA
TAM9A0C48V41DA
TAM9A0C60V51DA
NNoottee:: “Graphics in this document are for representation
only. Actual model may differ in appearance.”
NNoottee:: For use with BAYEA series heaters ONLY
Installer’s Guide

Ingersoll-Rand TAM9A0A24V21DA Specifications

General

Model Number	TAM9A0A24V21DA
Manufacturer	Ingersoll-Rand
Category	Air Handlers
Air Handler Type	Variable Speed
Nominal Airflow (CFM)	2400

Summary

Safety and Installation Basics

Safety Warnings and Precautions

Critical warnings on electrical, refrigerant, and physical hazards.

Installer Guide Notes

Key installation guidance, compliance, and system notes.

Unit Design and Preparation

Unit Design and Cabinet Access

Details on cabinet penetration, panel removal, and disassembly.

Unit Preparation and Accessories

Initial unit prep, optional accessories, and location considerations.

Installation Procedures

Unit Placement and Orientation

Guidance on carrying, placing, and configuring unit orientation.

Vertical and Horizontal Setup

Procedures for vertical and horizontal unit setup.

System Connections

Ductwork and Refrigerant Lines

Guidelines for connecting ductwork and refrigerant lines.

Condensate Drain Piping

Procedures for installing condensate drain lines.

Electrical Systems

Low Voltage Wiring and Controls

Instructions for low voltage wiring, controls, and interface.

High Voltage Power Supply

Guidance on making high voltage electrical connections.

Technical Operation and Diagnostics

Outline Drawing and Dimensions

Unit dimensions, clearances, and connection sizes.

Technician Menu and Configuration Tree

Details on technician menus, system configuration, and operation.

Filters and System Charge Adjustments

Information on filters and system charge adjustments.

System Start Up and Final Checks

System Start Up Procedures

Steps for powering up and starting the installed system.

Fault Reporting and Checkout Procedures

Procedures for fault reporting and final system checkout.