EasyManua.ls Logo

InHand IR300 Series - Power Installation

InHand IR300 Series
27 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8
Note
IR300 support dual antennas, ANT antenna and AUX antenna. The ANT antenna is the antenna which
receives and transmits data, AUX antenna can only enhance the antenna signal degree and can not
receieve and sent data, so it can’t be used alone. Generally, only use ANT antenna.
3.5 Power Installation
The steps are as follows:
Step 1:
Remove power terminal from router;
Step 2:
Unscrew the locking screw on the power terminal;
Step 3:
Insert the power cable into the terminal and lock the screws
Figure 3-5 Power Supply Installation
3.6 Ground Installation
The steps are as follows:
Step 1:
Unscrew the ground nut;
Step 2:
Put the grounding ring of the cabinet ground wire into the ground stud;
Step 3:
Tighten the ground nut.

Related product manuals