14
4.2 SIM Card Dial-Up
Step 1:
Insert the SIM card into the slot 1, /3 G/4G LTE the antenna to the ANT antenna column under the
power condition of the equipment, connect the network wire to the PC and connect to the power supply.
Attention
SIM card must be replaced or plugged, power off restart to avoid data loss or equipment damage.
Step 2:
Open the browser, login device WEB interface. (refer to 4.1 Wired Connections >> first and second
steps)
Step 3:
Click on the navigation bar "network >>Cellular" set dial-up access parameters, the device initial
default on dial-up function, wait a few minutes to access the Internet.
(if not dial-up,you can restart Cellular Service).
Figure 4-2-1 SIM Card Dial-Up
Step 4:
The device supports dual card mode, when the SIM card insert card slot 2, need to enable dual SIM
card function in advanced settings, private network dial parameters can be set in the dial
parameter set, new click on the application, and then select at the cellular network operator.
Figure 4-2-2 Dialing Parameters
To Next Page
Loading...
