InHand IR615-S Series - Page 49

43
SSLv3/TLSv1 protocol are massively used.
In OpenVPN, if a user needs to access to a remote virtual address (address family matching
virtual network card), then OS will send the data packet (TUN mode) or data frame (TAP mode) to
the visual network card through routing mechanism. Upon the reception, service program will
receive and process those data and send them out through outer net by SOCKET, owing to which,
the remote service program will receive those data and carry out processing, then send them to
the virtual network card, then application software receive and accomplish a complete
unidirectional transmission, vice versa.
From navigation tree, select "VPN>>OpenVPN", then enter “OpenVPN” page, and click <Add>.
Table 3-6-6 IPSec Configuration Parameters
OpenVPN
Function description: Configure OpenVPN parameters.
Parameters
Description
Default
Tunnel Name
OpenVPN tunnel name, cannot be changed
by the system
OpenVPN_T_1
Enable
Click to enable
Enable
Mode
Client/server
Client
Protocol
UDP/ICMP
UDP
Port
Set port
1194
OPENVPN Server
Set OPENVPN Server address
N/A
Authentication method
N/A, pre-shared key, username/password,
digital certificate (multiple client), digital
certificate, username+digital certificate
N/A
Local IP Address
Set local IP address
N/A
Remote IP Address
Set remote IP address
N/A
Remote Subnet
Set remote subnet address
N/A
Remote Netmask
Set remote subnet mask
255. 255.
255. 0
Link Detection Interval
Set link detection interval
60 s
Link Detection Timeout
Set link detection timeout
300 s
Enable NAT
Click to enable NAT
Enable
Enable LZO
Click to enable LZO compression
Enable
Encryption Algorithms
Blowfish(128)/DES(128)/3DES(192)/AES(128)
/AES(192)/AES(256)
Blowfish(128)
MTU
Set max. transmission unit
1500
Max. Fragment Size
Set max. fragment size
N/A
Debug Level
Error/warning/information/debug
Warning
Interface Type
TUN/TAP
TUN