INIM Electronics SmartLine020-4

SmartLine
Conventional fire detection control panel
Extinguishant system control panel
Alarm transmission and fault warning routing
equipment with integrated power supply equipment
Installation and programming manual
EN 54-2
EN 54-4
EN 54-21
EN 12094-1
0051
0051-CPR-1412
0051-CPR-1413
0051-CPR-1414

INIM Electronics SmartLine020-4 Specifications

General

Brand	INIM Electronics
Model	SmartLine020-4
Category	Control Panel
Language	English

Summary

General Information and Compliance

Safety Laws and Device Handling

Ensures proper installation, handling of electronic devices, and system setup.

Installation Instructions

Connecting Detection Lines and IO

Illustrates wiring for detectors, call points, and I/O lines.

Power, Battery, and Thermal Probe Installation

Details connecting mains power, batteries, and the thermal probe.

System Power-Up and Configuration

Wiring Integrity Testing

Details the procedure for checking wiring integrity before system power-up.

System Powering Up Procedure

Guides on powering up the system, reset signalling, and initial checks.

Programming from Panel

Configuring Control Panel and Zones

Explains panel configuration and programming zone parameters.

Programming IO Lines and Outputs

Details programming parameters for I/O lines and various outputs.

Detection Line Threshold Adjustment

Extinguishant Board Programming

Configuring and Programming the Module

Describes configuring and programming the extinguishant module's principles.

RS485 BUS Device Configuration

System Maintenance Procedures

Zone Testing and IO Output Force Status

Details zone testing and manually forcing I/O line output status.

Diagnostics and Fault Solutions

Fault Diagnosis: Open and Shorted Circuits

Describes how to diagnose and resolve 'Open' and 'Shorted' faults.

Troubleshooting Repeater and Battery Faults