InMode VOTIVA - Section 9 - Troubleshooting; Description of Faults

Votiva Operator Manual DO607094B 44
Section 9 – Troubleshooting
The device provides monitoring of all critical parameters to ensure the safety of the
patient and user. If any of the following faults are detected, the System automatically goes
to STAND BY mode.
Description of Faults
System did not turn on
• Check power cord connection
• Check that main switch on rear panel is on
• Check fuses on back panel of the System
• Call Technical Service if problem persists
Software plug missing
• The software plug is not inserted
Checksum
• The software was not loaded properly from software plug
• Check plug connection and reboot the System
• Call Technical Service if problem persists
Fault H8002 - Handpiece is not connected
• Check connection of Handpiece
• Replace Handpiece
• Call Technical Service if problem persists
Fault H8005 – System Memory Fault
• Call Technical Service if problem persists
Faults H8003, H8006, H8007 - RF Related Faults
• Call Technical Service if problem persists