Chapter 1: Customer Information
Thank you for purchasing an Inmotion Controls, Inc. radio remote control.
READ ALL INSTRUCTIONS CAREFULLY BEFORE MOUNTING, INSTALLING AND
CONFIGURATING THE PRODUCT.
This manual includes general information concerning the operation of the radio remote control transmitter.
General Information on Safety
•Persons under the influence of drugs and/or alcohol and/or other medicine that impairs their reaction may not
assemble, disassemble, install, put into operation, repair or operate the product.
•All conversions and modifications of an installation/system must conform to the relevant safety requirements.
Work on the electrical equipment must be performed only by qualified, authorized personnel and in accordance
with the relevant safety requirements.
•In the event of malfunctioning, visible defects or irregularities, the product must be stopped, switched off and
the relevant master switches must be switched off.
FCC Part 15 (FCC ID: RN489896162JK01)
* This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference and (2) this device must accept any interference received,
including interference that may cause undesired operation.
* You are cautioned that changes or modifications not expressly approved by the party responsible for
compliance could void your authority to operate the equipment.
European Union Regulatory Notice
This device bearing the CE marking is in compliance with the essential requirements and other relevant
provisions of Directive 1999/5/EC. This device complies with the following harmonized European standards.
Safety: EN 60950-1:2006+A11:2009+A1:2010+A12:2011
EMC: ETSI EN30 1489-1 V1.9.2 2001-09; ETSI EN 301 489-3 V1.4.1 2002-08
Radio: ETSI EN 300 220-1 v2.4.1: 2012; ETSI EN 300 220-2 v2.4.1: 2012
The following CE marking is valid for EU harmonized telecom products.
IC Statement (IC: 10821A-8989616201)
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
To Next Page
Loading...