EasyManua.ls Logo

Innokin itaste mvp 2.0 User Manual

Innokin itaste mvp 2.0
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
WARNING:
1. The iTaste MVP is intended for use by people of legal
age (18+), NOT by non-smokers, children, women
who are pregnant or breaseeding, people with or
at risk of heart disease or people taking medicaon
for depression or asthma. The iTaste MVP is neither
intended for or marketed as a quit smoking aid or
cessaon device.
2. This unit may include small parts, please keep out of
reach of children and pets.
3. Don’t abuse your iTaste MVP even though it’s made
of metal, you may damage it by dropping it.
4.
Don’t aempt to repair the unit by yourself as
damage or personal injury may occur.
5. In order to guarantee the normal funcon of your
iTaste MVP and maintain the effect of vaping, we
suggest that you charge your baeries when they are
below 10% power.
6. In order to prolong the funcon of your iTaste MVP ,
please don’t place it in any environment that is too
hot or too cold too hot or too cold environment.
7. Please obey local laws or regulaons while vaping. If
there are any bans or potenal dangers, please keep
the iTaste MVP off.
8. Your iTaste MVP is not waterproof, please keep it dry.
9. Keep your iTaste MVP from sources of excessive heat.
10.Please don’t drop, throw or abuse your iTaste MVP ,
you may cause damage to outer shell or Inner
components.
11.Innokin is not responsible for baery or charge cable
explosions due to the use of low quality wall charger.
iTaste MVP doesn’t come with any wall charger . We
recommend you use high quality USB wall charger
with 5V 500mA (CE&UL cerfied) . This will takes you
about 2.5h fully charge your iTaste MVP .
12.Use lower waage for low-resistance (ohms)
accessories and higher waage for high-resistance
(ohms) accessories
Warranty
Please consult with Innokin official distributors for their
warranty and return policy. Innokin’s warranty does
not apply to products purchased through third party
vendors.
ITaste MVP is a microprocessor controlled VV/VW
personal vaporizer that lets you easily adjust the
voltage and waage with just a few buon presses.
Specificaons:
Main Features:
Variable Voltage:
voltage can be adjusted from 3.3 – 5.0 volts in .1 volt
increments.
Variable Waage:
Waage can be adjusted from 6.0 – 11.0 W in .5 was
increments.
Ohms meter :
Reads resistance of your atomizer/cartomizer/clearomizer.
MVP 2.0
Operang Voltage :
3.3V-5.0V
Operang Waage : 6.0W-11.0W
Baery capacity : 2600m Ah
Size : 23*41*107mm
Puff counter will record the number of puffs you have
taken. Either press “P “buon or “U” buon 1 second
to check puffs ,The Puff Counter will be cleared when
the device is turned off.
Puff Counter:
Please read the instrucons and precauons before
using the iTaste MVP
If the buon is held down for 10 seconds or longer,
the iTaste MVP will shut itself off unl the buon is
released and pressed again.
The iTaste MVP uses a built in Micro USB Port. You can
recharge it with a Micro USB cable. It can also work as
a pass-through for use while charging.
Remembers last set voltage or waage when the
baery is turned off and then back on.
Digital display shows Ohms meter, Voltage /Waage
seng, number of puffs taken since last me the
baery was turned off.
Short Circuit/Atomizer Protecon protects the iTaste
MVP against shorted atomizers.
The iTaste MVP monitors the baery voltage and will
automacally turn off when the baery is discharged.
The iTaste MVP baery capacity is displayed via
green, yellow and red LED lights.
Green = Fully Charged
Yellow = Half Discharged
Red = In need of charging
iTaste MVP e-cigaree built-in 2600 mAh polymer
Li-Ion rechargeable baery.
Short Circuit/Atomizer Protecon:
Over-Discharge Protecon:
Baery Level Indicator:
Large baery capacity:
High compability 510 connector:
Thread fit iClear10,iClear16 ,iClear30 etc
ON/OFF baery switch:
Quickly clicking“ ”three mes will enable or disable
the baery. Once enabled, holding down the buon
will acvate the baery.
This safety feature prevents the atomizer from
turning on while it's in your pocket or bag and it
prevents any sengs from geng changed without
you knowing.
10 seconds cutoff:
Passthrough:
Remembers last set voltage or waage :
Built-in 3 digit display :
USER MANUAL
Question and Answer IconNeed help?

Do you have a question about the Innokin itaste mvp 2.0 and is the answer not in the manual?

Innokin itaste mvp 2.0 Specifications

General IconGeneral
Battery Capacity2600mAh
Output Voltage3.3V - 5.0V
Charging PortMicro USB
Threading510
OLED DisplayYes
Power bank functionYes
Resistance Range1.0Ω - 3.0Ω
Maximum Output Current3.5A
Output Wattage6.0W - 11.0W
MaterialStainless Steel
FeaturesVariable Voltage, Puff Counter, Battery Level Indicator

Summary

Safety and Precautions

General Warnings

Read instructions and precautions, keep away from children, avoid dropping or attempting repairs.

Battery and Charging Safety

Use high-quality USB chargers (5V 500mA), charge below 10% power, avoid extreme temperatures.

Usage Regulations

Obey local laws, keep device dry, avoid excessive heat sources, do not drop or throw.

Warranty Information

Warranty Policy

Consult official distributors for warranty and returns; not applicable for third-party purchases.

Product Specifications and Features

Specifications

Size, operating voltage (3.3-5.0V), operating wattage (6.0-11.0W), battery capacity (2600mAh).

Key Features

Variable Voltage/Wattage, Ohms meter, Puff Counter, Short Circuit Protection, Battery Level Indicator.

Connectivity and Power

High compatibility 510 connector, ON/OFF switch, 10-sec cutoff, Passthrough charging, remembers settings.

Operation Guide

Portable Power Source

Use the small pin switch to power electronic devices via USB OUTPUT port.

Device Controls

Overview of the three main buttons: Power, P, and U buttons for changing settings.

Power On/Off

Quickly click the power button three times to enable or disable the battery.

Variable Voltage Mode

Press 'U' for 3 sec to enter, adjust voltage from 3.3-5.0V in 0.1V increments.

Variable Wattage Mode

Press 'P' for 3 sec to enter, adjust wattage from 6.0-11.0W in 0.5W increments.

Information Display

Hold 'P' and 'U' for 2 sec for resistance, voltage, puff count, and last setting.

LED Battery Indicator

LED light colors (Red, Yellow, Green) indicate battery voltage and charge status.

Usage Notes and Tips

Refill cartridge, avoid powering without atomizer, start with low voltage settings.

Charging the iTaste MVP

Charging Process

Plug USB cable into device and power source; LED indicates charging status.

Passthrough Charging

Device can be used while recharging via Micro USB cable.

Related product manuals