Innova ITM4800 - Assembly Step 3: Backrest to Base Frame; Backrest to Base Frame Attachment

2
47
Front
Rear
Installed
Correctly
Before Installation, Please NOTE:
Connecting Brackets (11R&11L) MUST
be pointing downward and the Pre-
Installed Backrest MUST be attached from
below and up into the connecting brackets
or the table will not invert properly.
Step 3 – Pre-Installed Backrest to Base Frame
7
TIGHTEN ALL NUTS AND BOLTS
AT THIS TIME
Installed Incorrectly
Attach the Pre-Installed Backrest
(2&47&47A) to the Connecting Brackets
(11R&11L) using 4 Bolts (29), 4 Flat
Washers (19) and 4 Lock Nuts (21).
Screw the Angle Selector Pin (14) into
the Incline Position 15 hole and tighten.
Headrest Adjustment: To adjust the
Headrest (47A), unscrew Bolts (61) and
Washers (51) and remove it from the
Backrest Support Tube (2). Move the
Headrest (47A) to the position desired on
the Backrest Support Tube (2) and screw
2 Bolts (61) and 2 Washers (51) to
secure the Headrest (47A) into place.
Middle Position
High PositionLow Position
47A
61
2
47A
61
2
47A
61
2
Connecting Brackets Must Point Downward
When Attaching Pre-Installed Backrest
47A
47
2
11R
11L