What to do if my Innova Inverter makes a strange noise?
If your Innova Inverter is making a strange noise, it could be due to the fan touching the structure. Check the filters for clogging and clean them if necessary. Alternatively, the fan might be unbalanced, causing excessive machine vibrations, in which case you should replace the fan.
What to do if my Innova SL leaks water only during the cooling function?
If your Innova Inverter leaks water only during cooling, the condensation bowl might be blocked. To resolve this, slowly pour a bottle of water into the lower part of the battery to check the drainage. If necessary, clean the bowl and consider increasing the inclination of the drainage pipe. Also, ensure the connection pipes and valve unit are well-insulated.
Why Innova SL ventilation does not activate even if there is hot or cold water?
If the Innova Inverter ventilation doesn't activate despite available hot or cold water, several issues could be the cause: * The hydraulic valve might be closed. Try to dismount the valve body and check if the water circulation is restored. * The fan motor could be blocked or burnt out. Check the motor windings and ensure the fan rotates freely. * The micro-switch, which stops ventilation when the filter grill is opened, may not be closing correctly. Verify that the micro-switch contact is activated when closing the grill. * Incorrect electrical connections may also be to blame. Check all electrical connections.
What to do if my Innova SL leaks water during heating?
If your Innova Inverter leaks water during heating, there could be leaks in the hydraulic connections. Check for any leaks and fully tighten the connections. Alternatively, there might be leaks in the valve unit, so inspect the condition of the gaskets.
Why there are formations of dew on the front panel of Innova SL?
If you notice dew forming on the front panel of your Innova Inverter, it could be due to thermal insulation that has become unstuck. Check the positioning of the thermo-acoustic insulation, especially above the finned battery.
How to solve delayed ventilation activation in Innova Inverter?
If you experience a delay in ventilation activation with your Innova Inverter after adjusting the temperature or function settings, it's likely because the circuit valve needs time to open, delaying the circulation of hot or cold water. Allow 2 to 3 minutes for the circuit valve to fully open.
Why there are drops of water on the air outlet grill of Innova SL Inverter?
If you see water drops on the air outlet grill of your Innova Inverter, especially at minimum ventilation speeds, it's likely due to high humidity (above 60%) causing condensation. This should disappear as humidity decreases. The presence of a few water drops doesn't necessarily indicate a malfunction.
Technical data tables for 2-pipe and 4-pipe configurations.
Overall dimensions for SL, RS, and SLS units in 2-pipe configuration.
General| Input Voltage | 12V DC |
|---|---|
| Output Voltage | 120V AC |
| Output Waveform | Modified Sine Wave |
| Frequency | 60 Hz |
| Cooling | Fan |
| Protection Features | Overload, Short Circuit |
To Next Page