Inovance IS650PT037IUX Series - Chapter 4 Quick Setup; Quick Setup: Initial Checks

3 Keypad and Display
3
- 27 -
Figure 3-4 Keypad operation of user password setting
View value of
H02-30
Set password
Display
"Er.941"
Password
take effect
Display
"- - - - -"
Display
"Done"
Display
"Error"
End
Power-on
No
Yes
"SET"
Power-on again
"SET"
Yes
No
Enter preset
password
Password
correct?
"MODE"
SET
UP
SET
Last digit
blinking?
Return to
H02-30
display
Start
"SET"
"SET"
Note
*1: If the last digit does not blink, password protection is enabled. If the last digit blinks,
password protection is disabled or the correct password has been entered.
When modifying the user password, enter the correct password so that you have the rights
of parameter setting. Enter H02-30 again, and you can set a new password according to
the method described in the preceding gure.
Canceling User Password
Enter the existing user password, and set H02-30 to "00000". Then, the user password is cancelled.