Product Information
‑10‑
Figure 1‑2 Dimensions of MD500‑EM1 card (unit:mm)
1.4 Interface Layout and Description
The hardware layout of the MD500‑EM1 card is shown in "
Table 1–1
"
on page 11
. The
pin header J7 on the back of the MD500‑EM1 card is used to connect the AC drive.
Two Ethernet interfaces J4 and J6 enable the MD500‑EM1 card to communicate with
the Modbus‑TCP master or slave. For details about the hardware, see "
Table 1–1
"
on
page 11
.
To Next Page
Loading...