Communication Parameters
‑21‑
Parameter Name
Value
FD‑37
DHCP enable
0
FD‑38
IP address highest byte
192
FD‑39
IP address second highest byte
168
FD‑40
IP address third byte
0
FD‑41
IP address lowest byte
6
FD‑42
Subnet mask highest byte
255
FD‑43
Subnet mask second highest
byte
255
FD‑44
Subnet mask third byte
255
FD‑45
Subnet mask lowest byte
0
FD‑46
Gateway highest byte
192
FD‑47
Gateway second highest byte
168
FD‑48
Gateway third byte
0
FD‑49
Gateway lowest byte
1
When using the DHCP BOOTP function, you can check the MAC address by either
viewing the label information on the expansion card, or viewing the corresponding
function code of the AC drive.
The expansion card also supports the IP address conflict detection. When the IP
address of the expansion card is the same as other devices in the network, the D7 red
indicator will be steady on. In this case, the value of parameter FD‑58 is 84.
The IP address conflict may be detected in the following three circumstances.
To Next Page
Loading...