Enter each digit slowly and distinctly. The lock signals at each entry.
If a mistake is made press ‘#’ to clear.
Factory-set Master code: 00-12345678 (Change immediately after installation).
This code is for resetting the lock. Please keep it safe.
Factory-set Manager code: 01-123456 (Change immediately after installation).
This code opens the lock and can add or delete a second (02) user if required.
Opening the Lock for the first time
Enter Manager ID and code (01-123456)
the keypad will beep and flash green 3 times. 3 red
flashes indicate wrong code (see “Wrong Try Penalty”)
Turn keypad clockwise 1/4 turn within 3 seconds.
Open safe, turn handle, if any, and open safe door.
Now change your Master and Manager code
0 1 1 2 3 4 5 6
Changing the Master Code
Press #52 to put lock in program mode.
The green led will stay on during this process.
If the light goes out, restart the process
Enter ID (00) plus existing 8-digit code (12345678)
Enter ID (00) and new 8-digit code
Enter ID (00) and new 8-digit code again and press
the purple button to complete the process. The keypad
will beep and flash green 3 times. 3 low beeps and 3 red
LED flashes will indicate code not changed.
# 5 2
0 0
1 2 3 4 5 6 7 8
0 0
X X X X X X X X
0 0
X X X X X X X X
Enter each digit slowly and distinctly. The lock signals at each entry.
To Next Page
Loading...
