Insignia Diamond Series - Connecting to Bluetooth; Tuning Radio Channels

www.insigniashowers.com Last Modied: 17/05/2021
34
Control Panel Instructions
Step 2
Then simply go on your device and pair
up with the shower which should be
shown as “INS”. Once this is complete
you will hear a beep to signify you’re
connected and ready to listen to any
music of your choice.
Connecting to Bluetooth
Step 1
To tune your radio channels
rstly press the music
funcon buon (which looks
like a musical note)
Tuning your radio channels
Step 1
To connect a device via
Bluetooth, press the music
funcon buon twice (which
looks like a musical note) the
control panel will then show
“INS”.
Step 2
Then once the radio is on
press and hold the mode
buon unl it starts scrolling.
Step 3
Finally, once the panel has
nished scrolling then use the le
and right arrows to cycle through
all the radio staons that were
found.