Insignia Diamond Series - Steam Room Usage Guide; Operating the Steam Function

www.insigniashowers.com Last Modied: 17/05/2021
37
Steam Room Usage Guide
1. To use the steam room, turn the control panel on. (1)
2. Press the steam buon (2) and your generator will be fed with water and the heang
element will begin to heat the water to create steam. (You should be seeing steam from
your outlet in approximately 60-90 seconds)
3. To set the temperature you want the cabin to reach, press the funcon buon (3) once
the steam is acve. You will see a small °C to the right of the display. The large number in
the middle of the display can be changed by pressing the arrows (4). The maximum
temperature you can reach is 60°C . The average temperature in a steam room is
approximately 38°C .
4. To set the length you wish the steam to run for, press the funcon buon again (3) then
use the arrows (4) to set your desired me. The maximum length that can be set is 60
minutes.
5. You should only steam for approximately 15-20 minutes per session at it’s desired
temperature. Due to the heat, your body can overheat, dehydrate and cause light
headedness. This is very important if you are very new to steam rooms.
1
2
3
4
4