Insignia NS-15AT08 - Status items; Notifications; Get started

3
other voice conversation application or are performing a voice search on Google.
8
Micro USB port
Plug the micro USB end of the cable into this port.
9
Micro SD card slot
Insert a micro SD™ memory card into this slot to expand the storage capacity of
your tablet.
10
Reset hole
Insert a paperclip or pin into this hole to reset your tablet, then turn it on again.
Package contents
 Insignia Flex™ Android Tablet
 USB power adapter
 Micro USB cable
 QUICK SETUP GUIDE
 IMPORTANT INFORMATION
Setting up your Tablet
Your tablet has a built-in battery. The battery can only be replaced by the original manufacturer.
Before using your tablet for the first time, you need to charge the battery for a minimum of eight hours.
Warnings:
• Do not crush, puncture, short external contacts, or dispose of battery in fire or water.
• Do not expose to temperatures above 40°C (104°F).
To charge the battery:
1. Insert the USB connector on the Micro USB cable into your tablet’s micro USB port.
2. Insert the other end of the USB cable into the USB power adapter.
3. Plug the USB power adapter into a power outlet to start charging the battery.
When the battery is charging, the battery charging icon appears at the bottom right corner of the screen if your tablet is turned on.
After the battery has been fully charged, the (full battery) icon appears at the bottom right corner of the screen if your tablet is turned on.