EasyManua.ls Logo

Insignia NS-ANT20DA - Features; Mounting Your Antenna; Wooden Wall Mounting

Insignia NS-ANT20DA
10 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
FEATURES
40-mile range for superior reception, even in difficult locations
Amplifier included to boost weak signals from far away
Designed for indoor and outdoor use
Resistant to summer and winter elements
Water-proof and anti-UV housing with a lightweight, compact, and stylish design
Full kit of installation parts included for mounting to exterior walls, roofs, attics, poles, or
other surfaces
Works with 4K TVs
WARNING: Installation of this product near power lines is dangerous.
For your safety, follow the enclosed installation directions.
Before using your new product, please read these instructions to prevent any damage.
MOUNTING YOUR ANTENNA
Note: When using an electric drill, you should wear protective eye goggles and make sure that the
drill bit is installed correctly to avoid injury.
WARNING: Do NOT bend the flexible antenna base with the antenna attached. This can crack
the antenna’s plastic housing. To bend the flexible antenna base, remove the antenna and bend the
antenna base. Then, reinstall the antenna.
Wall mount
Wooden wall
1. Use the antenna base to mark the screw locations.
2. Attach the antenna base to a wall with the included screws (×4).
Notes:
• You may choose to pre-drill the holes using a 3/32″ drill bit.
• Make sure that the antenna base’s arm is upturned.

Related product manuals