Insignia NS-BC48SS7 Quick Setup Guide

V4 ENGLISH 17-0568
USING YOUR COOLER
Setting the temperature
• Press the Temperature up ( ) or down ( ) buttons, to increase or decrease the
temperature by one degree.
• The temperature range is 33-50° F (1-10° C).
• Press and hold the Temperature up ( ) or down ( ) buttons at the same time for
three seconds to switch between Fahrenheit and Celsius.
• If you experience a power outage, when your cooler is turned on again it resumes the same
temperature that was set when the power went o.
Using the display
• When you plug in your cooler for the rst time, the display screen turns on for three seconds,
and you hear a start-up tone.
• In normal mode, the display shows the set temperature.
Lighting your cooler
• Press Light ( ) to turn on or turn o the light. The buzzer sounds when the light is turned
on or o.
Entering standby mode
• Press and hold Standby ( ) for three seconds. The buzzer sounds and the display turns o.
• To return to normal mode, press Standby ( ) again.
Reversing the door
• See the online user guide for steps on reversing the door.
CLEANING YOUR COOLER
1 Turn o the cooler and unplug it from the wall outlet.
2 Remove all beer and beverages.
3 Wash the inside with a damp warm cloth soaked in a solution of one quart of lukewarm
water to two tablespoons of baking soda solution.
4 Be sure to keep the door gasket (seal) clean to keep the unit running eciently.
5 Dry the interior and exterior with a soft cloth.
TIPS ON SAVING ENERGY
• Place your cooler in the coolest area of the room, away from heat producing appliances or
heating ducts and out of the direct sunlight.
• Do not overload the cooler because it forces the compressor to run longer.
• Do not open the door too often, especially if the weather is very hot. Close the door as soon as
possible to prevent cool air from escaping.
• Make sure that the cooler is suciently ventilated with adequate air circulation.
SPECIFICATIONS
WARNING
Electric Shock Hazard
Failure to follow these instructions can result in electric
shock, re, or death.
1 WARNING–Keep ventilation openings in the appliance clear of
obstruction.
2 WARNING–Do not touch the interior of the freezer
compartment with wet hands. This could result in frost bite.
3 WARNING–Do not use mechanical devices or other means to
accelerate the defrosting process, other than those recommended by the manufacturer.
4 WARNING–Do not damage the refrigerant tubing when handling, moving, or using the
refrigerator.
5 WARNING–Do not use electrical appliances inside the food storage compartment of the
refrigerator, unless they are of the type recommended by the manufacturer.
6 WARNING–DANGER—Never allow children to play with, operate, or crawl inside the
refrigerator.
Risk of child entrapment. Before you throw away your old refrigerator or freezer:
1) Take o the doors
2) Leave the shelves in place so that children may not easily climb inside
7 Unplug the refrigerator before carrying out user maintenance on it.
ONEYEAR LIMITED WARRANTY
Visit www.insigniaproducts.com for details.
CONTACT INSIGNIA:
For customer support, call 1-877-467-4289 (U.S. and Canada) or 01-800-926-3000 (Mexico)
www.insigniaproducts.com
INSIGNIA is a trademark of Best Buy and its aliated companies.
Distributed by Best Buy Purchasing, LLC
7601 Penn Ave South, Richeld, MN 55423 U.S.A.
©2017 Best Buy. All rights reserved.
Made in China
TROUBLESHOOTING
Fault indication
• If a fault is detected, the display shows one of the following codes:
If either of these error codes appears on the display, please contact your local dealer or service
center. Do not try to repair the cooler yourself.
PROBLEM:
The cooler does not
operate.
The cooler door does not
close completely.
The cooler is not cold
enough.
The cooler makes unusual
noises or vibrates.
Moisture is building up in
the interior of the cooler.
The cooler turns on and
o frequently.
SOLUTION:
• Make sure that the cooler is plugged in and that the plug
is pushed completely into the outlet.
• Check the house fuse/circuit breaker box and replace the
fuse or reset the circuit breaker.
• If a power failure occurs, the cooler turns o. Wait until
the power is restored, then turn it on again.
• Adjust the shelf properly.
• Clean the door gaskets.
• Level the cooler with the leveling feet.
• Make sure that the door is closed properly.
• Allow time for the new beverage to cool, then check
again.
• Set the control to a colder setting.
• Level the cooler with the leveling feet.
• Move the cooler out from the wall.
• This is normal.
• Make sure that the door is closed properly.
• Move the cooler to a dryer location.
• Cool the room or move the cooler to a cooler location.
• Make sure that the door is closed properly.
• Clean the door gaskets.
• Set the control to a colder setting.
FAULT CODE
Description
E1
Temperature sensor fault
E4
Defrost sensor fault
Dimensions
48 can
78 can
115 can
Weight:
48 can
78 can
115 can
Power requirements:
48 can
78 can
115 can
Current:
48 can
78 can
115 can
Operating temperature:
(W×D×H):
18.9 × 17.3 × 19.4 in.
(48 × 44 × 49.2 cm)
18.9 × 17.3 × 25.3 in.
(48 × 44 × 64.2 cm)
18.9 × 17.3 × 33.1 in.
(48 × 44 × 84.2 cm)
50.7 lbs (23 kg)
59.5 lbs (27 kg)
70.5 lbs (32 kg)
115V~60Hz-65W
115V~60Hz-65W
115V~60Hz-80W
0.8A
0.8A
1.1A
33-50 F
NS-BC48SS7_BC84SS7_BC120SS7_BC120BS8_17-0568_QSG_V4_EN.ai 2 7/13/2017 10:54:43 AMNS-BC48SS7_BC84SS7_BC120SS7_BC120BS8_17-0568_QSG_V4_EN.ai 2 7/13/2017 10:54:43 AM

Insignia NS-BC48SS7 Specifications

General

Brand	Insignia
Model	NS-BC48SS7
Category	Accessories
Language	English