PACKAGE CONTENTS
• Battery pack
• Micro USB charging cable
• Quick Setup Guide
CHARGING YOUR BATTERY PACK
1 Plug the charging cable into the battery pack’s micro USB port
(input).
2 Plug the other end of the charging cable into a USB port on your
computer, vehicle charger, or wall charger (not included). The
battery pack automatically begins charging.
CHARGING YOUR DEVICE
1 Plug the USB cable into the battery pack’s USB port (output).
2 Plug the other end of the USB cable into your device, then
press Power.
Note: If your device requires a dierent connector, use the cable
that came with your device.
CHECKING YOUR BATTERY LEVEL
Note: Recharge your battery pack when the LED blinks.
• • • • 4 LEDs = 75-100% power
• • • • 3 LEDs = 50-75% power
• • • • 2 LEDs = 25-50% power
• • • • 1 LED = 0-25% power
Blinking LED = <10% power
Before using your new product,
please read these instructions to prevent any damage.
USB (output)
Power button
Quick Setup Guide
|
NS-MB5200B
Mobile Battery Pack
LEDs
Micro USB
port (input)
To Next Page
Need help?
Power
Battery
