5
14 Cu. Ft. Chest Freezer
www.insigniaproducts.com
Installing the handle and lock latch
1 Align the lock latch with the two holes on the front of the freezer cabinet, then
secure it with two screws using a Phillips screwdriver.
2 Align the door handle with the four holes on the front of the freezer door.
3 Secure the door handle with four screws using a Phillips screwdriver.
4 Press the screw cover onto the door handle.
Note: The screw cover arrives partially attached to the door handle. Remove the
screw cover to install the handle. The screw cover is not intended to be removed
after it is fully attached.
Note: The screw cover is not intended to be removed after it is fully attached.
To Next Page
Loading...
