www.insigniaproducts.com
39
NS-HF2007
STEP 32:
You need:
1 Align a drawer support (OO) with the holes on the inside of the left drawer side (P), then insert two 3.5 × 12 mm screws
(NN) through the outside of the drawer and into the support.
2 Tighten the screws with a Phillips screwdriver.
3 Align a drawer support (OO) with the holes on the inside of the right drawer side (Q), then insert two 3.5 × 12 mm
screws (NN) through the outside of the drawer and into the support.
4 Tighten the screws with a Phillips screwdriver.
NN 3.5 × 12 mm
screw (4)
OO Drawer support (2)
Phillips screwdriver
P Left drawer
side (1)
Q Right drawer
side (1)
OO
NN
NN
OO
OO
To Next Page
Loading...
