17
1.6 Cu. Ft. Portable Top-Load Washer
www.insigniaproducts.com
Installing in an alcove or closet
Minimum clearances between your washer and adjacent walls or other
surfaces are:
• Either side: 1 in. (2.5 cm)
• Rear: 6 in. (15.2 cm)
• Closet Front: 2 in. (5.1 cm)
• Top: 24 in. (61 cm)
If you install your washer and dryer side-by-side in a closet, the closet
front must have an unobstructed air opening of at least 72 square inches
(465 square cm).
Electrical requirements
Use a 120 Volt, 60Hz, 15 amp fuse or circuit breaker. We recommend an
individual branch circuit that serves only your washer.
Warning: To reduce the risk of fire, electric shock, or injury to persons, read the
IMPORTANT SAFETY INSTRUCTIONS before operating this appliance.
Warning: To reduce the risk of fire, electric shock, or injury to persons, read the
IMPORTANT SAFETY INSTRUCTIONS before operating this appliance.
Warning: The electrical valve and capacitor of this appliance are intentionally not
grounded and may present a risk of electric shock during servicing. Do not contact
these electronic devices while the appliance is energized. Electrical grounding is
required for your washer.
1 in.
20.3 in. (51.5 cm)
1 in.
2.5 cm
2.5 cm
2 in.
5.1 cm
20.7 in. (52.5 cm)
3.9 in.
24 in. (61 cm)
10 cm
To Next Page
Loading...
