Inspire FT2 - Page 27

48
47
5
STEP 17 Book/Accessory Rack
A) Attach the Book/Accessory Rack Support (47) to the two holes in the middle of the
Rear Upright (5), using 2-M10x80 Hex bolts (83), 4-M10 Curved Washers (99), and
2-M10 Locknuts (98). Tighten these bolts now.
B) Attach the Book/Accessory Rack (48) to the Book/Accessory Rack Support (47) using
2-M10x20 Button Head Bolts (94), 4-M10 Flat Washers (97), and 2-M10 Locknuts
(98). Tighten these bolts now.
PAGE 24
2 – M10*20 Button Head Bolts (94)
4 – M10 Flat Washers (97)
2 – M10 Locknuts (98)
2 – M10*80 Hex Bolts (83)
4 – M10 Curved Washers (99)
2 – M10 Locknuts (98)