What’s in the box
1 x Assembled Room Thermostat consisting of
1 x Room Thermostat
1 x Battery Cover
1 x Wall Mount
1 x Wall Blanking Plate
1 x Assembled Relay Module consisting of
1 x Control Board
1 x Wall Mount
1 X Front Cover
1 x Screw Pack
2 x Batteries
Introduction
The Ignite Wireless series is designed to control a typical domestic central heating system.
The Relay module can switch two independent channels. This would usually be the Central
Heating and the Hot Water.
The central heating channel is switched on and off in response to commands from the
supplied Wireless Thermostat.
The Hot Water channel is switched on and off at the programmed time intervals that the
user sets. (When in Auto Mode)
1
Ignite Wireless Installation Guide Rev 1.0
WARNING Electricity is dangerous. Before commencing work, ensure that you read and understand these
instructions and isolate the relevant circuit. This product should only be installed by a qualified electrician or
heating engineer and should be installed in accordance to BS 7671 (IEE Wiring Regulations), or to another
equivalent standard.
To Next Page
Need help?
General
