What’s in the box
1 x Assembled Room Thermostat consisting of
1 x Room Thermostat
1 x Wall Mount
1 x Wall Blanking Plate
1 x Screw Pack
Introduction
The Ignite wired Thermostat is designed to replace an existing wired Thermostat in a
property. Please ensure your existing Thermostat has at least a 3 core cable.
If you do not have an existing wired Thermostat, you would need to run a cable, or consider
using our Ignite Wireless series. Once installed, your central heating can be switched on and
off in response to commands from the Thermostat or remotely using a computer or Smart
Phone.
1
Ignite Installation Guide Rev 1.0
WARNING Electricity is dangerous. Before commencing work, ensure that you read and understand these
instructions and isolate the relevant circuit. This product should only be installed by a qualified electrician or
heating engineer and should be installed in accordance to BS 7671 (IEE Wiring Regulations), or to another
equivalent standard.
To Next Page
Need help?
General
