1
6.
After using underwater, remember to shake the camera and allow it time to dry naturally. Do
not use a hair dryer to dry the microphone and speaker holes, as this may damage the internal
waterproof membrane.
7. To keep GO 3 in good, waterproof condition, avoid using GO 3 in high humidity environments
for longer than one hour. This may include saunas, steam rooms or hot springs.
Tips: The suggested working temperature is -4°F-104°F (-20°C-40°C).
8. Do not store in high temperature or humidity environments. Do not store with perfume,
cosmetics or other chemicals that may interfere with the charge points.
9. Do not drop GO 3 or apply strong pressure to the camera, as this will damage it.
10. Do not disassemble GO 3.
1. GO 3 (excluding Action Pod) is waterproof to 5m right out of the box, no other protective
casing is needed. For extended use underwater or to dive deeper, please use the GO 3 dive case
(please refer to the dive case's instructions for details).
2. Before using underwater, ensure the GO 3 Lens Guard is installed. Without this, GO 3 is not
waterproof. Screw on the Lens Guard tightly to prevent any image quality issues.
Note: the Lens Guard comes pre-installed on GO 3.
3. The GO 3 Action Pod is only splashproof (IPX4 water resistant). Do not use the Action Pod in
water.
4. Before use, make sure GO 3's back cover and the Action Pod charging points are both free of
dirt or debris.
Charging Points
Speaker
Microphone
5. After using GO 3 in water (without the Action
Pod), clean and dry it thoroughly with a soft cloth.
Failure to properly dry GO 3 may results in damage
to the camera. Make sure the charging points are
dry and clean before placing it into the Action Pod.
Note: If using in salt water, soak the camera in fresh
water for 15 minutes, then dry.
English
To Next Page
Loading...
Need help?
General
Weight and Dimensions
