23
Waterproofing
• Insta360 X4 is waterproof up to 10m (33ft) without a Dive Case. Remove the Lens
Guards before using the camera in water, as they are not recommended for
underwater use.
• For optimal stitching effects underwater, use the official X4 Invisible Dive Case. Its
design compensates for light refraction and maintains waterproofing up to 50m
(164ft).
• After each use in seawater, soak the camera in fresh water for 5-10 minutes,
gently rinse it, and then thoroughly dry it with a soft cloth. Ensure it is completely
dry before further use.
• Check that the battery compartment and USB Port Cover are free from dirt or
foreign objects. Ensure both are securely closed to maintain waterproofing. The
orange indication marks on the battery compartment should be fully covered.
To Preserve Waterproofing:
• Avoid using a hair dryer to dry the camera, as it may damage the microphone,
speaker, and internal waterproofing.
• Operate the camera within the recommended temperature range -20°C to 40°C (-
4°F to 104°F) and avoid extended operation (>1 hour) outside this range or in
humid environments.
• Store the camera in environments with moderate temperature and humidity;
avoid high-temperature or high-humidity environments.
• Avoid entering water at high speeds to prevent potential damage from excessive
water impact and pressure.
• Ensure the camera's Battery Cover and USB Port Cover are installed and securely
closed to maintain waterproofing.
Cleaning
• If foreign objects like dirt or hair are present on the Lens Cover, clean it using
clean water or a lens pen, air blower, or cloth.
• If foreign objects like dirt or hair are present on the lens, use a lens pen, air
blower, or cloth to clean it.
• Ensure the Battery and Battery Cover are free from dirt and foreign objects such
as sand or hair. Clean them with a soft, dry cloth or paper if necessary.
• Ensure the MicroSD Card slot is free from dust, dirt, and sand to ensure proper
camera functionality.
To Next Page
Loading...
