4
M
N 4 O N N P
Motion Detected
Motion Enabled
Error Controlling a Device
Motion Disabled
Low Battery
Motion Override Button
Tap to toggle motion
detection enable/disable.
All other sensor features
are not affected. Motion
detection will automatically
resume after 12 hours.
Set Button
Tap to send on/off commands
to linked devices.
Link: press & hold until LED
blinks green.
Unlink: press & hold until LED
blinks green. Press and hold
again until LED blinks red.
For more functions see Local
Programming
Battery Compartment
Tamper Switch
Not Pictured
Micro USB
Optional power
through Micro USB
(cable sold separately)
CR123A Battery
Depending on
activation frequency,
the battery should last
6 to 18 months
On
Off
Status LED
To Next Page
Loading...
Need help?
General
