InStep 11-AR108 - Attach the Front Wheel


7

 Posion the stroller so the handle rests on the ground, with
the front fork facing up. 
 Move the quick release lever into the open posion.
 Set wheel into the forks, ensure the axle is properly seated,
and hand ghten the cone nut.
 Close the quick release lever to the fully closed locked
posion. When closing the lever it should leave an imprint
on your hand. The lever should have rm but not
excessive pressure when closing.
 Pull on the wheel to ensure it is locked in place. If necessary
loosen the quick release lever and re-ghten the cone nut.
Re-check the wheel to be sure it is locked into place.

If the front wheel is not securely locked in place it may
fall o the jogging stroller and cause serious injury or
death. Always check the front wheel is securely locked in
place before use.
2
3
4
1