User's Manual No. 9999-064-0
_________________________________________________________________________________________________
_________________________________________________________________________________________________
B7250_simplex_E_01.doc Rel. 1 vom 01.07.2005 1
User's Manual CombiStar 7250 simplex
Security note
• In the interest of security, change the factory CODE 1 2 3 4 5 6 immediately after
installation.
• Never use data, such as a birthday, which others could deduce from personal
information about you when choosing your CODE.
• Once the new CODE has been entered, and with the door open, lock and unlock the
electronic lock several times using the new CODE.
• Attention! Don´t turn key pad with a higher power than 10 Nm.
Opening the electronic lock with the CODE
Correct CODE must be entered twicein sequence when:
There has been an interruption of power supply, such as when changing
battery or after entering more than four times a wrong code.
After entering the CODE, open the electronic lock within 10 seconds with the keypad, otherwise the
electronic lock will close automatically.
If incorrect CODES are entered four times in sequence, then a 10-second penalty time-out
period will start running. See Page 4, >Optical and acoustic signals<
Electronic lock Electronic lock
CLOSED OPEN
Closing the electronic lock
The electronic lock will engage automatically 10 seconds after it is opened.
To finally lock the safe it will be necessary to rotate the keypad once again into its "home" position.
Electronic lock Electronic lock
OPEN CLOSED
Before leaving the safe it is absolutely necessary to rotate the keypad several times to ensure
that the electronic lock is closed properly.
To Next Page
Loading...
